Advertisement

New SiC Diodes Make Converters More Efficient

In the recently ended project MV-SiC, these diodes were tested in the sort of commercial converters used for large drives. SiC diodes reduce the complexity of the system, and because they have lower losses, they also increase energy efficiency. Another result is that the switching frequency of converters can be increased by approximately a third, which boosts the performance and speed range of the drives. Siemens managed the project, and it was funded by the German Federal Ministry of Education and Research as part of the program Power Electronics for Raising Energy Efficiency. With frequency converters electric motors can operate at variable-speed. When used for large pumps, compressors, or ships, such motors consume up to 70 % less power than motors without any speed control. Considering that drives of this kind have an output of several megawatts, the savings are quite significant. Outputs on that scale require converters that produce voltages of several kilovolts. In the past, such converters were made of conventional silicon semiconductors. In the course of the project, the partners Infineon, Curamik Electronics, TU Dresden, and experts from Siemens Drive Technologies and Global Research Department Corporate Technology (CT) studied diode modules based on SiC which have a cut-off voltage of 6,5 kV and can withstand currents of up to 1,2 kA. By connecting bipolar SiC high-voltage diode chips in parallel, it was possible to construct functional SiC diode modules with the desired electrical parameters. To optimize the switching behavior, the partners built a fully digital drive circuit. This allowed them to achieve high switching frequencies and a high switching speed, which resulted in much lower turn-on losses. The work done by Siemens CT focused on the thermal behavior of the chips and diode modules. These are crucial factors for the reliability and lifetime of the diode modules, because the conducting-state voltage decreases with increasing temperature in a SiC diode. Experts from Siemens Drive Technologies tested the new modules as midpoint diodes in Sinamics GM150 converters. This standard converter system for single drives was built with a 6,5 kV SiC diode module, which reduces the complexity and, therefore, the material requirements of the design while increasing efficiency.

Service

Phone: +49 7221 502 200


E-mail: info@goeller-verlag.de